Sensors
Der WattNode 480 VAC 3-Phasen-Delta/Wye kWh Transducer Sensor arbeitet mit Magnelab AC-Stromwandlern und einem Pulse Input Adapter, um echte RMS-Kilowattstunden der verbrauchten Energie zu liefern, sogar für Lasten mit nicht-sinusförmigen Wellenformen.
CHF 469.00
SKU
T-WNB-3D-480
- 10 für jeweils CHF 454.95 kaufen und 3% sparen
- 25 für jeweils CHF 445.55 kaufen und 5% sparen
- 50 für jeweils CHF 431.50 kaufen und 8% sparen
- 100 für jeweils CHF 412.75 kaufen und 12% sparen
Overview
Provides accurate measurement at a low cost to meet your needs for sub-metering, net-metering, energy management, and performance contracting applications. This WattNode Delta or Wye-connection kWh Transducer works with Magnelab AC Current Transformers and a Pulse Input Adapter to provide True RMS kilowatt hours of energy used, even for loads with non-sinusoidal waveforms. Because these sensors tie directly into the line, they should only be used by qualified personnel. This model supports a 3-phase Delta-connection of 480 VAC.
Features
- Measures 1, 2, or 3 phases in 2, 3, or 4 wire configurations
- Use with wide choice of CTs (sold separately); ratings from 5 to 1500 amps
- Accurate measurement of 1-,2-, or 3-phase configurations
- Easy to install and wire
- Pulse output: compatible with pulse input logger models
- Small size: can be installed in existing service panels or junction boxes
- Diagnostic LEDs: confirms proper installation for all phases
- Bidirectional metering: net metering for PV (photovoltaic) solar and wind power generation with only one meter
- Metering of variable frequency drives
- Line powered: no external supply required
- Detachable terminal blocks: easy to install and remove.
- UL, cUL listed: designed and tested for safety and use throughout North America
- CE Mark: can be installed throughout the EU
Specifications
Operating: voltage range: ±20% of nominal
Frequency: 60 Hz
CT input: 0-0.5 VAC operating, 3 VAC maximum
Connectors: UL, CSA recognized, detachable screw terminals (14 AWG), 600V
Operating temp range: -30 to 60°C (-22 to 140°F)
Operating humidity range: 0 to 90% RH, non-condensing
Dimensions: 8.5 cm x 14.3 cm x 3.8 cm (3.3 in. x 5.6 in. x 1.5 in.)
Weight: 295 g (10.4 oz.)
Number of data channels: 2
To download the manual from Continental Control Systems LLC click here.
Below is a diagram of a typical installation
- Delta or Wye configuration ranges: 480 Volts AC
- 3 Phase 3 Wire(No neutral)
- 3 Phase 4 Wire
- Accuracy: ±0.45% of reading + 0.05% FS through 25th harmonic
- (dependent on CT used and line variation accuracy could be 1.5% to 4% of reading)
Accessory
AC Current
Pulse Input
Voltage Input Lead Set
Additional Compatible Products
Sensors
Data Logger
USB Data Loggers - requires external sensor(s)
USB Data Loggers - w/external sensor(s)
Web-based Monitoring Systems - via remote communication
